Video showing how to install the amp behind the back seats. And where to run the power wire to the battery. I also ran the remote wire to the head unit as well here. Materials Used: Panel Removal Kit 3/8" Galvanized Rod - (2x) 3" Pieces 3/8" Nuts&Washers 1/2" MDF 32"x16" With Notch Cut Kicker ZX700.5 5 Channel Amplifier Kicker CK44 4-Channel Amp Install Kit Any Questions, Post In The Comment Section Below. For now I have only ran the Power and remote wires. When it is warm again here I will do the opposite side of the truck and post a part two on how to run the speaker wires to the head unit. **Side Note: The Back of the 1/2" MDF Board has a recessed area behind each 3/8" Nut to allow the board to go completely flush with the truck body. I forgot to mention in the audio. Thanks for watching!
Sunday, November 18, 2012
2010 F-150 Amplifier Installation Part One
2010 F-150 Amplifier Installation Part One Tube. Duration : 9.65 Mins.
Video showing how to install the amp behind the back seats. And where to run the power wire to the battery. I also ran the remote wire to the head unit as well here. Materials Used: Panel Removal Kit 3/8" Galvanized Rod - (2x) 3" Pieces 3/8" Nuts&Washers 1/2" MDF 32"x16" With Notch Cut Kicker ZX700.5 5 Channel Amplifier Kicker CK44 4-Channel Amp Install Kit Any Questions, Post In The Comment Section Below. For now I have only ran the Power and remote wires. When it is warm again here I will do the opposite side of the truck and post a part two on how to run the speaker wires to the head unit. **Side Note: The Back of the 1/2" MDF Board has a recessed area behind each 3/8" Nut to allow the board to go completely flush with the truck body. I forgot to mention in the audio. Thanks for watching!
Video showing how to install the amp behind the back seats. And where to run the power wire to the battery. I also ran the remote wire to the head unit as well here. Materials Used: Panel Removal Kit 3/8" Galvanized Rod - (2x) 3" Pieces 3/8" Nuts&Washers 1/2" MDF 32"x16" With Notch Cut Kicker ZX700.5 5 Channel Amplifier Kicker CK44 4-Channel Amp Install Kit Any Questions, Post In The Comment Section Below. For now I have only ran the Power and remote wires. When it is warm again here I will do the opposite side of the truck and post a part two on how to run the speaker wires to the head unit. **Side Note: The Back of the 1/2" MDF Board has a recessed area behind each 3/8" Nut to allow the board to go completely flush with the truck body. I forgot to mention in the audio. Thanks for watching!
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment